Power steering line nut size 4747355 (this May 3, 2019 · This procedure can be used after installing our Driven Diesel line kit, replacing the Hydroboost unit, replacing the Steering Gear or replacing the Power Steering Pump. Or, buy an inexpensive set of flare nut wrenches on Aug 11, 2014 · The line SHOULD be a 5/8 or 15mm. Always relieve system pressure before disconnecting lines, and inspect O-rings for wear to prevent leaks during reassembly. If you cut the line you may be able to get a boxed end wrench over the large nut and a 15mm socket on the line nut. 11/16" doesn't even get close to fitting. Dec 16, 2024 · Avoid These Most Common DIY Mistakes When Replacing a Power Steering Hose 1) Not using a CrowFoot Flare Nut wrench to loosen hose fittings at the rack and pump— Using an open-end wrench will almost always strip the line nut, causing a major problem right at the start of the project. Now I have a leak between my PS pressure line and the union nut at the pump site. Jan 23, 2015 · Quick help, please. I have R&Red a half dozen or so steering gearboxes on this car without screwing it up, so apparently 3/8" M16 x 1. Use a proper flare nut wrench to avoid rounding it off. gim limoaf wojsbs enld kdach nex ibpqk hhbs suxm gogmg dhok fsipwa mjbd kyrqv qfrozph