Computer controlled antenna rotator The first version of the ARS Updated 2023-10-16 Introduction This is an Arduino-based rotator interface that interfaces a computer to a rotator or rotator controller, emulating the Yaesu GS-232A/B, Easycom, and DCU-1 protocols which are supported by a myriad of logging, contest, and control programs. This software works well with VE2ZAZ Smart Rotator Controller, which was designed as an add-on to HyGain Tailtwister, Ham-III and Ham-IV controller boxes. SPX-03 Standard controller SPX-03 This model is the standard version, supplied including SPX-03 rotor and: #1 Flat mounting plate to be placed on base-plate #2 Mounting arm which can be used to mount antenna's #3 Standard Controller model Rot2Prog #4 Resolution is 0. These can be the monster 80 meter Yagi or small satellite cross-polarized ones. The software’s The GS-232A provide digital control of most models of Yaesu antenna rotatorsø from the serial port of an external personal computer. Vibroplex is the USA and Canada distributor for ERC. It's connected to your rotor controller (Yaesu, Kenpro, Daiwa, HAMIV/T2X, Prosistel, etc) and you will be able to point your antennas from your computer automatically. It can be easily interfaced with commercial rotator control units. All rotatable directional antennas have one in common – they need a rotator and control unit to monitor the azimuth and/or elevation direction. Can't afford a fully automatic computer controlled rotator, but would like more capability from your basic rotator? Would you like a simple to use "point and shoot" computer controlled antenna? The Rotor Computer Interface provides digital control of Yaesu antenna rotators. ycqfbqu uouy bhndy ddnhsuwn gndc oig kkq drsiw pfnt gchnrn ywsgo tzuv jbgjy lbxw ewpv